G.S.I DC Installation and Operation Guide
23
Figure 28: Reception Test Screen
To end communication manually:
Press
and
simultaneously. Communication immediately ends.
The controller display returns to the Main screen.
Manually Setting the Controller Clock
In order for the controller to correctly operate the irrigation system at
the desired times, the controller clock must first be set correctly. The
controller clock is automatically updated every time the controller
performs communication with the server.
However, if necessary, you can also manually set the time.
To manually set the controller time:
1.
Press and hold
until the hour and minutes values in the displayed
time start running. This indicates that the clock is in time-setting
mode. Set the current time using the
and
buttons.
2.
Press
to exit time-setting mode, and press
repeatedly until the
Main screen is displayed. Verify that the time you set is correctly
displayed.
Testing Station Operation
The station operation test is intended to verify that all of the solenoids
have been correctly installed. As you perform the test for each station,
verify that water is flowing by checking the controller, the flow sensor,
or even by visually inspecting the sprinklers to check that water is
flowing from them.
