G.S.I DC Installation and Operation Guide
14
Inserting Batteries
The G.S.I DC Controller comes pre-installed from Galcon with a pack of
four Lithium batteries (3.6 V each battery and 14.4 V in total).
If you need to replace the Lithium pack, contact your Galcon distributor.
Alternatively
, if you are unable to find a Lithium pack of four 3.6 W
batteries, you can insert four D-size alkaline batteries.
To insert batteries:
1.
Unlock and open the controller cover (Figure 18).
2.
Swing out the control panel (Figure 19).
3.
For the internal casing on the right side, unscrew the two screws
and open the casing (Figure 20).
4.
Turn the battery compartment latch by 90 degrees and pull out the
battery compartment (Figure 21).
Figure 21: Battery Compartment Removed
