27/86
Gala Gar, S.L. c/ Jaime Ferrán, 19 (Políg. Cogullada) | Tel.: (+34) 976 47 34 10 - 50014 ZARAGOZA |
SMART 210 TIG PULSE
Protection function
When the overcurrent indicator illuminates and the digital meter displays “E-1”, it indicates that overcurrent
occurs. Restart the machine, and welding can be continued.
When the under-voltage indicator illuminates and the digital meter displays “E-2”, it indicates that the mains
voltage is overly low, and welding can be recovered when the mains voltage goes into normal.
When the overheating indicator illuminates and the digital meter displays “E-3”, it indicates that welding is forced
to stop because the main circuit of the machine gets overheated. In this condition, It is unnecessary to turn off the
machine, but just wait a few minutes, and then welding can be continued.
When the current sensor fails and the digital meter displays “E-4”, welding may still be carried out. However, the
current value at this time is inaccurate.
Foot control option (customized)
This machine can identify the foot control automatically. That is to say, the machine will enter into foot control
mode automatically after the aviation plug of the foot control is connected to the welding machine and the
machine is powered on again. In foot control mode, the maximum current is the preset current and the minimum
current is 10A.
Voltage indicator (customized)
When this indicator illuminates, it indicates that there is voltage output at the output terminal of the welding
machine. When TIG is selected as the welding mode, there will be voltage output only when the torch trigger is
pressed continuously and after arc is ignited successfully. When MMA is selected as the welding mode, there will
be voltage output whether arc is ignited or not.
