SS1603-08 3G Audio Intercom (E5) 07262019
13
Progrmming by call
Note: programming by call
can’t be used from telephones which are already programmed to
open the door when they dial the 3G audio intercom but you can disable Caller ID display
(withhold the number) in the mobile before using.
To gain access to the programming mode by call follows these steps:
Example:
Storing a telephone number for dial in door release
Enter Programming Mode by Pressing
…..
*12*
1234
# (1234 is default password)
A successful pass code will produce a single long beep. A failed attempt will produce 3 short
bleeps.
You may now program up to 1150 telephone numbers into memory.
Use the following commands to program the unit
* Insert international country code (1~3 digits):
71 [ country code] #
* Add a number (up to 1150 numbers):
72 [relay][telephone number] #
* Delete a number:
73 [ telephone number ] #
* Delete all numbers:
73*#
ACCESS CONTROL OPTIONS
1. Caller ID recognition
2. Enter password code by call or send SMS
1. Caller ID recognition
If your number is saved inside the intercom memory, just dial the SIM card number held within
the unit to open your gates and it will activate the door or gate without answering your call.
* For Caller ID recognition to open the door or gate you need to program the mobile numbers
and country code into the memory before using.
