4
Installation
Important notes for installers
Qualified personnel only
Commander GSM telephones are supplied with one of several different power
supply options which may require connection of the power supply to an AC mains
outlet. The installation must only be carried out by appropriately qualified and
trained personnel. Contact GAI-Tronics if installation service is required.
DC power adapter
The DC power adapter supplied as standard with the Commander GSM telephone
is for in-building use only. Where the IP65 capabilities of the Commander GSM
telephone are to be employed by installing the telephone outside, and subject to
weather extremes, the DC power adapter must be either installed in-building or
correctly installed within an IP65 enclosure if located outside (enclosure not sup-
plied). The power adapter DC output is routed to the Commander GSM telephone
using suitable cabling.
Test tools required
During the testing and commissioning of the Commander GSM telephone, the use
of another mobile phone will be required in order to send status and configuration
commands via SMS text messages. Alternatively, a laptop computer can be used
connected to the internal USB port, see Appendices.
Avoid contamination during installation
All possible measures must be taken to ensure water, fluid or dust does not
contaminate the internal components of the telephone whilst unpacking, prepar-
ing and installing the telephone in inclement weather conditions or by negligence.
Failure to do so may invalidate your warranty.
Beware internal connections
The Commander GSM is normally delivered with the ringer cable and internal bat-
tery cable disconnected. Beware of the cable connections between the case front
and rear sections. Carefully separate the two sections.
Similarly when assembling the case front and rear sections beware of the cable
connections and ensure the cables do not get trapped in the seal between front
and rear sections. This may lead to damaged leads and could significantly reduce
the environmental protection offered to the internal components and will invalidate
the warranty.
Emergency Services warning
If the telephone is configured so that it cannot make a direct call to the emergency
services, check with your telephone service provider or infrastructure maintainer
whether it is necessary to warn users, and if so provide a suitable warning notice.
A warning label, which can be fixed to the front of the telephone, is provided.