ENGLISH
• 13 •
Keeping it clean:
1
IMPORTANT:
the steam nozzle should
be cleaned after each use in order to avoid
build up of milk deposits that are very difficult
to clean. Cleaning is made easy as can be
seen in the DESCRIPTION OF PARTS. The
outer part of nozzle can be removed by
pulling downward.
The outside of the steam pipe can be cleaned
with a damp cloth.
The steam jet is cleaned by running a shot
of steam through it.
The hole in the steam nozzle must be kept
open. A needle may be used.
2 Clean filter holder and filter in warm water
after use.
Pay attention as
the
Turbo-Frother
steam
nozzle could be hot
!
Air intake to be kept clean
and free from residues.
3 Wipe body of machine with a damp cloth
as required.
N.B.:
The machine has a sensitive keypad
activated by simply touching or brushing the
sensor areas (keys 2, 3, 5, 6). Turn off the
machine when cleaning in order to avoid
activating it by mistake.
4 Remove drip tray and plate (12-23) and
wash in warm soapy water. Do not use
abrasive substances.
5 Clean the seal (15) inside of the brewing
head (14) and keep it clean.
6 The shower disc (17) should be unscrewed
and cleaned periodically depending on
frequency of use.
7 If the machine is not used for a long period
of time, completely discharge the water
from the boiler by turning the steam knob
(25) clockwise. Press steam switch (5) until
completely discharged. Close the steam
knob (25) by turning it counterclockwise and
switch off the machine.
Never run the pump without water.
8
NOTE:
It is very normal for an espresso
machine to emit steam and drip occasionally
as the water pressure changes during use.
Be certain to empty drip tray (12) as required.
Making hot water:
1. Follow the procedure described under “
Pre-
paration
”.
2. Press the power switch (1).
3. Allow about 6 minutes for the machine to
reach its proper operating temperature.
4. Place a pitcher under the steam nozzle (8).
5. Slowly turn the steam knob (25) clockwise.
6. After obtaining the desired quantity of hot
water close the steam knob (25) by turning it
anticlockwise. Then remove the container.
The lights of buttons 2 - 3 - 6 will switch on
in a fixed mode.
N.B.:
A max.supply of 40 seconds is re-
commended.
Caution!
Scalding hazard! Splashing
may occur at the start – scalding ha-
zard! The hot water nozzle and pipe
can reach high temperatures: avoid touching
it directly with your hands.
