8.3 Nozzle replacement
Changing over to a different gas type
Only
authorised specialists
are permitted to
change over to a different gas type. The nozzles
needed for the gas type to be set are available as a
conversion kit. Please specify the appliance type
and the required gas type.
–
Disconnect the appliance from the power
supply.
– Remove the pot support, the burner ring, the
burner cover and the burner head.
– If the appliance is connected rigidly to a gas
main, it must be disconnected from the gas
network. If it is connected via a gas safety hose,
the appliance only needs to be pushed out of its
mount from below and taken out of the worktop.
– Undo the securing nut (SW 11) of the
thermocouple and the two securing screws that
become visible under the detached burner head
(Fig. 10).
– Remove the hob.
– Pull off the control knob. After undoing the
securing screws
(1)
on the left and right (Fig. 11),
you can remove the control panel by lifting
(2)
and pushing
(3)
it out of the latch (Fig. 12).
17
Fig. 11
Fig. 12
2
1
3
Fig. 10
