en
Installation instructions
34
26.10 Preparing the unit
ATTENTION!
A fan is located on the underside of this hob.
▶
If a drawer is located on the underside of the hob,
do not store any small or pointed objects, paper or
tea towels in it. These objects may be sucked in
and damage the fan or impair the cooling.
▶
There must be a clearance of at least 2 cm between
the contents of the drawer and the fan entry point.
Requirements
¡
The fitted units are heat-resistant up to 90 °C.
¡
The worktop is level, horizontal and stable.
1.
Follow the instructions on combining several appli-
ances.
→
"Combining multiple appliances", Page 33
2.
Ensure that the thickness of the worktop corres-
ponds to the required minimum thickness.
3.
Maintain the minimum clearance from the upper
edge of the worktop to the upper edge of a drawer
installed below it.
4.
Mark the unit cut-out in accordance with the installa-
tion diagram.
5.
Ensure that the angle of the cut surface to the work-
top is 90°.
6.
Remove dust and residues from the cut-out work.
Seal the cut surfaces so that they are heat-resistant
and waterproof.
7.
Provide an intermediate floor between the appliance
and the top drawer.
