Locking the control panel for cleaning
en
17
a
The cooking zone is switched off.
a
The residual heat indicator lights up.
14 Locking the control panel for cleaning
You can use this function to lock the control panel for
cleaning for a short time. You can remove liquids that
have boiled over without changing the settings you
have selected on the activated hob.
The function has no effect on the control knob. You
can switch off the appliance at any time. The power
supply to the appliance is interrupted while the lock is
on. The cooking zones may still be hot.
14.1 Activating the control panel lock for
cleaning
▶
Press .
The power supply to the appliance is interrupted
while the lock is on. The cooking zones may still be
hot.
a
A signal tone sounds.
a
The displays for the previously activated functions
flash.
a
The control panel is locked for 10 minutes.
a
The appliance switches off if you do not deactivate
the function within the next 10 minutes.
14.2 Deactivating the lock on the control
panel for cleaning purposes
▶
Press .
a
The function has now been deactivated.
15 Automatic switch-off
If you operate a cooking zone for an extended period
and do not change any settings, the automatic safety
shut-off is activated. Depending on which performance
level has been selected, the cooking zone switches off
automatically after 1 to 10 hours.
A signal tone indicates that the time has elapsed. The
illuminated ring on the control knob flashes orange and
white. The cooking zone stops heating.
lights up.
15.1 Switch-on time depending on the
power levels
The following overview displays the number of hours
after which the hob is switched off, depending on the
selected power level.
Power level
Time
10 hours
Power level
Time
-
5 hours
-
4 hours
3 hours
-
2 hours
-
1 hour
If you activate the frying sensor, the hob switches off at
power levels to after 3 hours.
15.2 Switching the appliance back on after
automatic switch-off
1.
Turn the control knob to 0.
2.
Turn the control knob for the required cooking zone
to the power level.
16 Basic settings
You can configure the basic settings for your appliance
to meet your needs.
16.1 Overview of the basic settings
This is where you can find an overview of the basic set-
tings and the factory preset values.
The display shows the settings
,
, and
only if
the appliance is connected to an extractor hood.
The display shows the settings and
only if the ap-
pliance is connected to an extractor hood with lighting.
Indicator Selection
Signal tones
All signal tones are switched on.
1
Only the fault signal is switched on.
1
Factory setting
Indicator Selection
Power management function. Limit the
total power of the hob. The available set-
tings depend on the maximum power of
the hob.
Deactivated.
1
Lowest level.
...
Highest level for the hob.
Check the cookware; cooking results
→
Not suitable.
Not perfect.
Suitable.
1
Factory setting
