Gaggenau VI 414 613, Use And Care Manual

Page: 35 / 40

35
Faults – what to do?
en-us
Notes
▯
If the fault code is not listed in the table, disconnect
the cooktop from the power supply, and wait
30 seconds before reconnecting it. If this code
appears again, contact technical Customer Service,
and specify which fault code has appeared.
▯
If a fault occurs, the appliance will not switch to
standby mode.
Demo Mode
If
š“ ‹¯
is displayed, demo mode has been activated.
The appliance will not heat up. Disconnect the appliance
from the power supply. Wait 30 seconds before
reconnecting it. Then deactivate the demo mode within
three minutes as follows:
1.
Turn the control knob anti-clockwise to the
Ž
position.
2.
Turn the control knob clockwise to position 1.
3.
Turn the control knob anti-clockwise to position 0.
The illuminated ring around the control knob will be lit
yellow.
4.
Turn the control knob clockwise to position 1. The
‹¯
display will be lit and the illuminated ring will be
green.
Wait for five seconds. The
‹””
display will be lit and
the illuminated ring will turn yellow.
Demo mode has now been deactivated.
Suitability Test of Cookware
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the cooking zone being
used.
1.
Fill the pan with approx. 8 oz. (200 ml) water and place
it in the middle at room temperature.
2.
Go to the basic settings, and select the
™„
setting.
The
‹””
indicator lights up.
3.
Touch the
@
or
A
symbol. The
‹¯
display will be lit.
An audible signal will sound and the cooking zone
indicator will be lit.
The function has now been activated.
The
¥—¯
display will be lit. After a few seconds, the
cooking zone display will show the results for the quality
and speed of the cooking process.
Check the result using the table below:
To activate the function again, touch the
@
or
A
symbol.
Notes
▯
Do not use the wok or wok accessories with this
function.
▯
If the diameter of the burner that is used is much
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
▯
You can find information about this function in section
~
"
Q
Basic Settings"
▯
You can find information about the type, size, and
positioning of the cookware in the section
~
"Cooking with induction"
“Š‹‹‹
“Š‹‚‹
The supply voltage is faulty/outside of
the normal operating range. Contact your energy provider.
—…‹‹
The cooktop is not connected properly Disconnect the cooktop from the power supply.
Check that the appliance has been connected as
shown in the circuit diagram.
Display Possible cause Remedial action
Do not place hot cookware on the control panel.
Result
‹
The cookware is not suitable for the cooking zone
and will therefore not heat up.*
‚
The cookware is taking longer to heat up than
expected and the cooking process is not going as
well as it ought to.*
ƒ
The cookware is heating up correctly and cooking
is progressing well.
* If there is a smaller cooking zone available, try the cook-
ware again on the smaller cooking zone.