6
Operating principle
The gas cooktop features teo normal burners (two
flame rings), two high output burners (two flame rings)
and a wok burner (three flame rings).
The appliance features one-hand operation, automatic
fast ignition, electronic flame detection and automatic
re-ignition.
The ignition is activated when the control knob is
turned. The flame size can be set continuously
between high and low.
Operation
The markings show the position of the corresponding
burner and the setting between high and low heat. The
flame setting is infinitely variable between high and
low heat.
Notes
‒
Only light a burner if all pan supports and burner
parts are properly assembled.
‒
Make sure the burners and electrodes are clean
and dry.
‒
Only use the recommended accessories. Do not
cover the stainless steel cooktop base (e.g. with
aluminium foil).
‒
Do not cover the air inlet at the back of the
cooktop.
Abnormal operation
Flames are usually blue and sharply defined. If the
flames are yellowish or noisy or if the gas does not
ignite within the period specified under "switching on"
abnormal operation is indicated. Refer to chapter
"After-sales service" of this manual for service contact
details.
Caution!
Heat damage to the extractor hood: Always
switch on the extractor hood while the gas cooktop is
in use. When using several cooking positions select a
higher fan level on the extractor hood. Make sure there
is a sufficient ventilation of the room.
Switching on
Your cooktop features automatic fast ignition.
1
Place a suitable pot or pan on the corresponding
cooking position.
2
Press down the corresponding control knob and
turn it anticlockwise to the required position. The
burner lights automatically.
The flame size can be set continuously between high
and low by slowly turning the control knob.
Notes
‒
When using large pots or pans you should ignite
the burner in the low position.
‒
Every time the gas hob is switched on, the
electronics run an auto test. All electrodes fire
and the required burner ignites after a few
seconds. When switching on further burners, only
the corresponding electrode fires.
2))
KLJKKHDW
ORZKHDW
