Troubleshooting
en
31
Information on display panel
Fault
Cause
troubleshooting
Message showing "D" or "E"
appears in the display.
The electronics have detec-
ted a fault.
▶
Call the after-sales service.
Temperature problem
Fault
Cause
troubleshooting
The temperature differs
greatly from the setting.
Different causes are pos-
sible.
1.
2.
Switch the appliance back on after
five minutes.
‒
If the temperature is too
warm, check the temperature
again after a couple of hours.
‒
If the temperature is too cold,
check the temperature again
on the following day.
Cool-fresh compartment is
too warm or cold.
Standard setting is too high
or too low, e.g. frost in cool-
fresh compartment.
Note:
The standard setting of the cool-
fresh compartment is preset at 0. Set-
ting 0 corresponds to a temperature of
around 0 °C. You can set the temperat-
ure in the cool-fresh compartment to
3 settings warmer or colder.
A change in the standard setting will
affect the temperature in the refriger-
ator compartment and the freezer
compartment.
1.
Press until the temperature dis-
play flashes.
2.
To change the setting, press / .
– Setting –3 corresponds to the
coldest setting.
– S3 corresponds to the
warmest setting.
a
The selected setting is saved after
one minute.
Noise
Fault
Cause
troubleshooting
Appliance has a humming
sound.
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
No action required.
