8
en
Installation and connection
Before using the appliance for the
first time
1
Remove information material, adhesive tape and
protective film.
2
Clean the appliance.
Water connection
Caution!
–
Installation and connection of the appliance must
be carried out by qualified technicians according to
the installation instructions supplied.
–
To avoid damage to the appliance and to ensure its
proper functioning, it should only be connected to a
drinking water system.
–
To avoid water damage, a shut-off valve must be
installed.
Water pressure of drinking water system
Caution!
If the water pressure exceeds the maximum value, a
pressure relief valve must be installed between the
drinking water connection and the hose set to avoid
damage to the appliance.
Note:
If the water pressure is too low, this will impair
the appliance functions.
▯
Min. 0.2 Mpa (2 bar/29 psi)
▯
Max. 0.8 Mpa (8 bar/116 psi)
Electrical connection
Caution!
Do not connect the appliance to electronic energy saver
plugs.
Note:
You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are directly connected to the national
grid. Sine-controlled inverters must be used for isolated
applications.Isolated applications, e.g. on ships or in
mountain lodges, which are not directly connected to
the national grid.
1
After installing the appliance, wait at least 1 hour
before connecting it to avoid damaging the
compressor.
2
Connect the appliance to a correctly installed
socket.
The socket must comply with the following data:
Outside Europe: Check whether the indicated
current type of the appliance corresponds with the
values of your power supply. The appliance
specifications are specified on the rating plate.
"Getting to know your appliance" on page 9
3
Connect the appliance to a socket near the
appliance.
The socket must also be freely accessible after
installation of the appliance.
m
Warning – Risk of electric shock!
If the length of the mains cable is insufficient, do
NOT use multi-outlet power strips or extension
leads.Instead, please contact Customer Service for
alternative solutions.
Socket with
220 V ... 240 V
Protective conductor
50 Hz
Fuse
10 A ... 16 A
