Gaggenau RF411304, User Manual

Page: 14 / 29

14
en
Operating the appliance
Display lock for cleaning
You can use this function to switch off the touch
function of the controls for 10 seconds. During this time
you can clean the display.
~
"Cleaning the display" on page 24
1 Press
à
button to open the main menu.
2 Press
I
button.
The cleaning display appears and the countdown starts.
Switching ice cube production on or
off
Caution!
Damage to the appliance!
Never store bottles or food in the ice cube container,
even for short periods. This can block and damage the
ice maker.
Ice cube production starts as soon as the appliance has
reached the set temperature.
Note:
Ice cube production stops automatically when the ice
cube container is full.
Switching ice maker on or off
1 Press
à
button to open the main menu.
2 Use
C
button to move to the menu item Ice cube
production .
3 Press
I
/
&
button.
Eco mode
Eco mode switches the appliance to energy-saving
operation.
The appliance automatically sets the following
temperatures:
▯
Freezer compartment: -16 /3
Switching Eco mode on or off
1 Press
à
button to open the main menu.
2 Press
C
button to move to the menu item Eco
mode .
3 Press
I
/
&
button.
The temperature is changed and the display shows the
new temperature. When Eco mode is switched off, the
recommended temperature is set.
Note:
You can also switch Eco mode on or off by adjusting the
temperature with the
A
/
@
buttons.
Reset water filter counter
If you are using a water filter in your appliance instead
of the particle filter supplied, you have to reset the water
filter counter whenever you have replaced the water
filter.
~
"Switching the water filter counter on and off"
on page 15
1 Press
à
button to open the main menu.
2 Use
C
button to move to the menu item Reset water
filter counter .
3 Press
™
button to confirm and confirm the query
again with
™
button.
Note:
If you cancel the query or take longer than 10 seconds
to make an input, the water filter counter will not be
reset.
Self-test
This function can be used to start fault analysis on your
appliance.
~
"Appliance self-test" on page 28
Setting the brightness of the control
panel
1 Press
à
button to open the main menu.
2 Press
B
button to move to the menu item Basic
settings .
3 Press
™
button.
4 Press
%
button to open the menu item Brightness .
5 Press
B C
buttons to set the required brightness.
6 Press
™
button.
The setting is saved.
7 Press
'
button to exit the menu.