Operating the appliance
en
29
Switching the appliance on
1.
Turn on tap fully.
2.
Open the door.
3.
Switch on ON/OFF switch
(
.
The Eco 50° programme has been preset for
environmentally friendly operation whenever the
appliance starts. This programme remains selected if
no other programme button
0
is pressed.
4.
Press START button
)"
.
5.
Close the door.
Programme sequence starts.
Note:
For ecological reasons the Eco 50° programme is
preset whenever the appliance starts. This conserves
environmental resources and not least saves you money.
The Eco 50° programme is a particularly environmentally
friendly programme. According to EU regulation 1016/2010
it is the “Standard programme” which is the most efficient
standard cleaning cycle for cleaning normally soiled
utensils in terms of the combined energy and water
consumption for cleaning these types of utensils.
Time preselection
You can delay the start of the programme by up to 24
hours. Depending on the setting of the time display, the
end of programme is indicated with “Finish in” (for
example 3h 25m) or “Finish at” (for example 15:20
hours).
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Selects programme
0
.
4.
Press time preselection button
`
.
5.
Keep pressing the setting buttons
+ -
X
until the
displayed time corresponds with your requirements.
6.
Press START button
)"
, timer programming is
activated.
7.
To delete the time preselection, press START button
)"
for approx. 3 seconds.
Time preselection was terminated.
8.
Close the door.
Programme end
* The programme has ended when “Finished” is
indicated on the display window at the top
@
and on
the front display *
):
.
* The end of the programme is displayed on the floor –
provided the optical display is switched on and is
visible.
* depending on the features of your dishwasher
Switching off the appliance
Short time after the end of the programme:
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
3.
Turn off tap (does not apply to appliances with Aqua-
Stop).
4.
Remove the utensils when they have cooled down.
Note:
When the programme ends, leave the appliance
to cool down a while before opening it. This will prevent
steam from escaping and causing long-term damage to
your built-in furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause the appliance door
to jump open and/or water to escape! If the door was
opened on an appliance which has a hot water
connection or is heated, always leave the door ajar for
several minutes and then close.
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
The LEDs go out. The programme is saved.
3.
To continue the programme, switch on the ON/OFF
switch
(
again.
4.
Close the door.
