Gaggenau DF480161CN, Instruction Manual

Page: 31 / 48

Operating the appliance
en
31
Programme end
* The programme has ended when “Finished” is
indicated on the display window at the top
@
and on
the front display *
):
.
* The end of the programme is displayed on the floor –
provided the optical display is switched on and is
visible.
* depending on the features of your dishwasher
Switching off the appliance
Short time after the end of the programme:
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
3.
Turn off tap (does not apply to appliances with Aqua-
Stop).
4.
Remove the utensils when they have cooled down.
Note: When the programme ends, leave the appliance
to cool down a while before opening it. This will prevent
steam from escaping and causing long-term damage to
your built-in furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause the appliance door
to jump open and/or water to escape! If the door was
opened on an appliance which has a hot water
connection or is heated, always leave the door ajar for
several minutes and then close.
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
The LEDs go out. The programme is saved.
3.
To continue the programme, switch on the ON/OFF
switch
(
again.
4.
Close the door.
Terminating the programme (Reset)
Terminating the programme
1.
Open the door.
2.
Press the START button
)"
and hold for 3 seconds
The display window at the top
@
and the front
display *
):
show: "Program was terminated".
3.
Close the door.
The programme sequence lasts approx. 1 min. The
display window at the top
@
shows: “Finished”.
4.
Open the door.
5.
Switch off ON/OFF switch
(
.
6.
Close the door.
* depending on the features of your dishwasher
Changing the programme
When the START button
)"
has been pressed, the
programme cannot be changed. The only way
a programme can be changed is by Cancel programme
(Reset).