19
Operating the appliance
Optical display while the programme
is running *
Optical display while the programme is running
* depending on model
While the programme is running, an optical display
is indicated on the floor under the appliance door.
If the base panel is pulled forwards or if the appliance
is installed at eye-level with flush furniture front,
the display is not visible.
Possible settings of the optical display:
†
:
‹‚
is set at the factory.
To change the setting:
1
Open the door.
2
Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
`
until
•
:
‹
....
is indicated on the digital display.
4
Release both buttons.
The illuminated display of the button
#
flashes.
5
Keep pressing programme button
#
until the
previously set value, e.g.
†
:
‹‚
, is indicated
on the digital display
h
†
:
‹
... (for the optical
display).
6
Keep pressing programme button
3
until the
required value, e.g.
†
:
‹‹
, is indicated on the
digital display
h
.
7
Press START button
`
.
The set value is saved.
8
Close the door.
Remaining running time display
When the programme is selected, the programme
running time is indicated on the digital display
h
.
When the programme has started, the remaining
running time is displayed on the floor (only for
settings
†
:
‹‚
and
†
:
‹ƒ
).
The running time is determined during the programme
by the water temperature, the number of utensils
as well as the degree of soiling and may vary
(depending on the selected programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the programme in 1-hour
steps up to 24 hours.
1
Open the door.
2
Switch on ON/OFF switch
(
.
3
Press button
P
+ until the digital display
h
jumps to
œ
:
‹‚
.
4
Press
P
+ or – button until the displayed time
corresponds with your requirements.
5
Press START button
`
, timer programming is
activated.
6
To delete timer programming, press the
P
+ or
– button until
h
œ
:
‹‹
is indicated on the digital
display.
You can change your programme selection at any
time until the programme starts.
7
Close the door.
†
:
‹
‹
The display is switched off.
†
:
‹
‚
/
†
:
‹
ƒ
Programme, timer programming,
remaining time, end
of programme and, if required,
low water level are displayed.
