15
Filters
The filters
27
keep large foreign objects in the rinsing
water away from the pump. These foreign objects may
occasionally block the filters.
The filter system consists of a coarse filter, a flat fine
filter and a microfilter.
After each washing cycle check the filters for
residue.
Unscrew filter cylinder as illustrated and take out
filter system.
Remove any residue and clean filters under running
water.
Re-install filter system in reverse sequence and
ensure that the arrow marks are opposite each other
after closing the filter system.
Spray arms
Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms
24
and
25
.
Check outlet nozzles on the spray arms for
blockages.
Unscrew the upper spray arm
24
.
Remove the lower spray arm
25
upwards.
Clean spray arms under running water.
Re-engage or screw on spray arms.
Waste water pump
Large food remnants in the rinsing water not retained
by the filters may block the waste water pump. The
rinsing water is then not pumped out and covers the
filter. In this case:
First disconnect the appliance from the power
supply.
Remove the filters
27
.
Scoop out water, use a sponge if required.
Using a spoon, prise off pump cover (as illustrated)
until it clicks, then grip the cover by the lug and first
pull it upwards until it resists and then pull it out
forwards.
Check inner compartment and remove any foreign
objects.
Place cover in the original position, press down and
engage.
Install filters.
