37
Wireless temperature sensor
en
‚
Wireless temperature sensor
Wireless temperature sensor
Before you use the cooking sensor functions for the
first time, connect the wireless temperature sensor to
the control panel.
Preparing and maintaining the
wireless temperature sensor
This section provides information on:
▯
Adhering the silicone patch
▯
Attaching the wireless cooking sensor
▯
Cleaning
▯
Changing the battery
Silicone patches and cooking sensors can be
purchased from specialist retailers, our technical after-
sales service or our official website. Please quote the
relevant reference number when doing so:
Adhering the silicone patch
The silicone patch secures the cooking sensor to the
cookware.
If you are using a pot with the cooking sensor functions
for the first time, attach the silicone patch directly onto
the pot. Proceed as follows:
1
That the adhesive area on the pan is free from
grease. Clean the pan, dry it thoroughly and wipe
the adhesive area with a spirit.
2
Remove the protective film from the silicone patch.
Adhere the silicone patch to the outside of the pan
in the correct place using the enclosed template as
a guide.
3
Press down all over the surface of the silicone
patch, including in the centre.
The adhesive requires one hour to fully harden. Do not
use or clean the pan during this time.
Notes
–
Do not leave the pan with the silicone patch to soak
soapy water for long periods of time.
–
If the silicone patch comes off, attach a new one.
Fitting the wireless temperature sensor
Attach the temperature sensor to the silicone patch and
align it correctly.
Notes
–
Make sure that the silicone patch is completely dry
before attaching the cooking sensor.
–
Position the cookware in such a way that the
cooking sensor is pointing towards the outer side of
the hob.
–
To prevent overheating, do not attach the cooking
sensor to any other hot cookware.
–
Remove the cooking sensor from the pot after
cooking. Keep the cooking sensor away from heat
sources, and store it in a clean, safe place away.
–
You can use up to two cooking sensors at the same
time.
Connecting the wireless temperature
sensor to the control panel
To connect the wireless cooking sensor to the control
panel, proceed as follows:
1
Select the basic setting
™†
; see the section
entitled
. The
¨
symbol lights up white.
2
Touch the
¨
symbol. A signal sounds and the
¨
symbol lights up orange. The cooking zone
indicators light up white and the cooking sensor
indicators on the hotplates flash.
Briefly touch the
¨
symbol on the wireless cooking
sensor within the next 30 seconds.
00577921
Set of 5 silicone patches
CA060300
Cooking sensor and set of 5 silicone patches
