en
Home Connect
22
14.1 Setting up Home Connect
Requirements
¡
The appliance is connected to the power supply and
is switched on.
¡
You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡
The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
1.
Download the Home Connect app.
2.
Open the Home Connect app and scan the follow-
ing QR code.
3.
Follow the instructions in the Home Connect app.
14.2 Home Connect settings
You can adjust the Home Connect settings and network settings in your appliance's basic settings.
Which settings the display shows will depend on whether Home Connect has been set up and whether the appliance
is connected to your home network.
Symbol
Basic setting
Possible settings
Explanation
Connection type
LAN
Wi-Fi
You can switch between connection types (LAN cable
and Wi-Fi). Follow the instructions for setting up the rel-
evant connection type.
Connection
Connect
Disconnect
You can switch the network connection on or off as re-
quired. The network information is retained after the ap-
pliance is switched off. After switching on the appliance,
wait for a few seconds until it reconnects to the network.
Note:
In networked standby mode, the appliance re-
quires a maximum of 2 W.
Connect to app
Start the connection process between the app and the
appliance.
Software update
As soon as a new software version is available, a mes-
sage appears on the display. In the Home Connect
menu, you can install the new software using .
Remote control
Activate
Deactivate
You can use the Home Connect app to access the appli-
ance's functions. If the remote control has been deactiv-
ated, only the appliance's operating statuses are dis-
played in the app.
The remote control is only available if you set the rotary
selector to light position .
The light goes out after a few minutes.
Permanent remote
start
Activate
Deactivate
When permanent remote start is activated, you can start
and operate your appliance at any time without prior ap-
proval on the appliance.
Permanent remote start is only available if you set the
rotary selector to light position .
The light goes out after a few minutes.
Delete network set-
tings
You can delete all network settings from the appliance at
any time.
Appliance information
The display shows:
¡
MAC address COM module
¡
Appliance serial number
¡
Software version
Depending on the connection type, you can view more
information, such as the SSID network name, by touch-
ing the arrow button.
