Gaggenau BS455101, User Manual And Installation Instructions, Page: 33 / 64

Troubleshooting
en
33
5.
Press ​⁠ to confirm.
a The appliance starts the rinsing process.
a
Once the descaling programme has finished, a sig-
nal tone sounds.
a
The display shows a message.
Cleaning the water tanks
Once the descaling programme has finished, remove
any descaler residues from the fresh-water tank and
process-water tank.
1.
Remove the fresh-water tank and process-water
tank from the appliance.
2.
Remove the tank lids.
3.
Clean the fresh-water tank, process-water tank and
tank lids in the dishwasher or thoroughly by hand.
16.7 Removing the shelf supports
The wire racks can be removed for cleaning.
1.
Place a dishcloth in the cooking compartment to
protect the stainless steel from scratches.
2.
Undo the knurled nuts.
3.
Lift the shelf supports slightly sideways away from
the screw ​⁠ and pull them out towards the front ​⁠.
4.
Clean the shelf supports in hot soapy water or in the
dishwasher.
16.8 Fitting the shelf supports
ATTENTION!
Incorrect spare parts may lead to corrosion in the
cooking compartment.
▶
Only use the original knurled nuts.
1. Fit the shelf supports the right way round.
‒
Position the stop position in the rear area of the
cooking compartment.
2.
Slide the shelf supports onto the bolts at the back
and fit them at the front.
3.
Tighten the knurled nuts.
Note:
If you lose a knurled nut, you can order this as a
spare part from our customer service.
17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
17.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not
working. The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.