Gage CompuScope 85GC, Hardware Manual And Driver Installation Manual

Page: 87 / 174

CompuScope 85GC 81
CompuScope 85GC connectors and headers
CompuScope cards connect to the outside world through connectors, both analog (BNC) and digital
(CompactPCI Bus). This section describes these connectors for the CS85GC card.
The connectors and headers on the CS85GC card are shown below:
Figure 54: Connectors on CS85GC
•
CH 1 BNC connector is the single-ended input of channel 1 that is used to input an analog signal that is
sampled as Channel 1.
•
CH 2 BNC connector is the single-ended input of channel 2 that is used to input an analog signal that is
sampled as Channel 2.
•
External Trigger BNC connector is used to input an analog or digital signal, which may be used as an
External Trigger. External Trigger is defined exactly as in an oscilloscope: this signal can be used to
trigger the system but cannot be viewed or digitized.
•
CompactPCI
TM
connector is located at the rear of the card. This is an industry standard connector
that complies with all specifications of the CompactPCI
TM
bus.