Gage CompuScope 85GC, Hardware Manual And Driver Installation Manual

Page: 116 / 174

110 CompuScope 14100C
CompuScope 14100C compliance statement
Category Standards or description
EC Declaration of
Conformity – EMC Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61326 EMC requirements for Class A electrical equipment for
measurement, control and laboratory use.
1, 2, 3, 4, 5
IEC61000-4-2 Electrostatic Discharge (Performance criterion B)
IEC61000-4-3 RF Electromagnetic Field (Performance criterion A)
IEC61000-4-4 Electrical Fast Transient/Burst Immunity (Performance
criterion B)
IEC61000-4-5 Power Line Surge Immunity
(Performance criterion B)
IEC61000-4-6 Conducted RF Immunity (Performance criterion A)
IEC61000-4-11 Voltage Dips and Interruptions Immunity
(Performance criterion B)
EN 61000-3-2 AC Power Line Harmonic Emissions
Australia / New Zealand
Declaration of
Conformity - EMC Complies with EMC provision of Radio communications Act per the following
standard(s):
AS/NZS 2064.1/2 Industrial, Scientific and Medical Equipment: 1992
1, 2, 3, 4, 5
1 Emissions which exceed the levels required by this standard may occur when this equipment is
connected to a test object.
2 High-quality shielded cables must be used to ensure compliance to the above listed standards.
3 Clip-on ferrite beads must be applied to the mouse and keyboard cables equivalent to (Steward
part number 25A2025-0A0) as supplied by the manufacturer.
4 An empty unused slot must be maintained between the PC Controller and the CS14100C card
set.
5 Compliance demonstrated on the following configurations:
•
A two card Master/Slave configuration with 8 MegaSamples of memory (qty 2 cards
maximum)
•
A four card Master/Slave configuration with 1 MegaSamples of memory (qty 4 cards
maximum)