171
5. Driving guide
WARNING
● If the vehicle lighting system is
changed (for example, the headlamp
is modified), the IHC performance
may be degraded or the function may
not be available.
● In the case of oncoming non-motor
vehicles such as bicycles and
electric bicycles or pedestrians, the
IHC system shall be turned off in time
to prevent dazzling.
5.4.8 Radar and IFC sensor*
MMW radar sensor
The MMW radar sensor is installed in the
middle of the front bumper lower grille to
monitor traffic conditions and detect vehicle
ahead within a certain range from the vehicle.
The radar sensor must be adjusted and
calibrated under the following conditions:
-
The mounting bracket of the MMW radar
sensor has been removed and installed.
-
The MMW radar sensor has been
removed and installed.
-
Toe or rear wheel camber has been
adjusted during four-wheel alignment.
-
After a vehicle collision.
NOTE
● The adjustment and calibration of the
MMW radar sensor requires the use of
specific special tools and equipment.
If you need to adjust and calibrate the
MMW radar sensor, please be sure to
go to the GAC Motor authorized shop
for related work.
● When the MMW radar sensor fails or is
misadjusted, it may affect the ACC, ICA
or FCM.
Special instructions for MMW radar sensor
The MMW radar sensor is installed at the
front of the vehicle, and no obstacle is allowed
within the detection range of the MMW radar
sensor. Do not install license plate frame or
other obstacles when installing the front license
plate. Otherwise, the detection performance
of the MMW radar sensor will be affected,
resulting in the failure of the ACC, ICA or FCM.
