2. Operating System and Equipment
96
High Beam Flashing
–
Switch the Start switch or ignition switch
to “ON” position
–
Pull back (backward direction of the car) the
light combination switch lever to position 5 to
turn on headlight high beams.
–
Release the light combination switch lever to
let it return to position 4 to turn off the
headlight flashers.
Hint
Even if no light is turned on, high beams remain
on and
in the instrument cluster remains on
if the light combination switch lever is pulled
back (backward direction of the car).
Auto Lighting (Apply to Certain Models)
–
Switch the Start switch to “ON” position.
-
Turn the light switch to
position to
enable auto lighting.
Hint
●
With auto lighting enabled, lights of the
car will be turned on or off depending
on the environmental light. When the
environmental light outside the car
dims gradually, the position lights are
turned on firstly, and then the low
beams. When the environmental light
outside the car brightens gradually, the
low beams go out firstly, and then the
position lights. When entering or
exiting a tunnel or garage or other dark
environment, the position lights and
low beams will be automatically turned
on or off at the same time.
•
You can adjust auto lighting sensitivity
via the "Car Setting" under audio
system (please refer to Page 197). The
higher the sensitivity, the brighter the
lights.
Caution
• If the instrument cluster display
prompts "The sensor fails, please
control the lighting manually", and for
the sake of safety, the system will keep
low beams turned on. In this case, you
can choose to control the lighting
manually, and go to the authorized
GAC MOTOR dealer timely to have your
car checked and repaired.
•
Auto lighting may fail in heavily foggy
or misty weather. Manually turn on the
lights then.
