G-SPE
11. WH
Th
ea
fai
re
Fo
1
2
3
EED eS INSTA
HAT TO DO IN
he G-Tech RAID
ach of the disk d
il
p
ure, an audibl
ort the failed
NOTE: If G
(RAID 1, 5
However, t
drive shoul
ollow the steps
1.
Launch the
2.
Mute the ala
button.
3.
The GUI wi
An exclama
that the “S
portion of
G-SPEED e
In this e
to the G
connecte
ALLATION G
THE EVENT O
controller cont
drives in G-SPE
e alarm will sou
drive and its ph
G-SPEED eS was co
5 or 10), a drive f
he array is now in
d be replaced as so
below to identi
web GUI.
arm by clicking
ll display infor
ation mark on t
Status” of the
the GUI ind
eS unit has faile
xample there are t
-Tech RAID contro
ed to Port 2 of the
UIDE - Windo
OF A DISK DRI
tinually monito
EED eS. In the
und. The web
hysical position
onfigured in a prot
failure does not re
an unprotected st
oon as possible to
fy and replace
g on the <Beepe
mation like tha
the G-SPEED e
array is Crit
icates which
ed.
two G-SPEED eS un
ller. Drive 3 of the
G-Tech RAID contr
ows
IVE FAILURE
rs the health of
event of a disk
GUI will also
n.
tected RAID mode
esult in data loss.
tate and the failed
avoid data loss.
a failed drive.
er Mute>
at shown below
eS icon indicate
ical. The lowe
drive in whic
nits connected
G-SPEED eS
roller has failed.
f
k
w.
es
er
ch
4. Remove the f
G-SPEED eS
controller) by
and gently slid
WARN
drive
conne
follow
conne
REMO
LOSS
ON G
X
failed drive (In
connected to
y inserting the p
ding the drive m
NING: Make abso
indicated by the G
ected to the G-Tec
w the cable to ensu
ected to on the RAI
OVING THE WRON
S OF THE ARRAY A
-SPEED eS.
n this example
o port 2 of th
provided key in
module out of t
lutely sure that yo
GUI. If multiple G-
h RAID controller,
re you know which
ID controller.
NG DRIVE WILL R
AND ALL OF THE
Page
e Drive 3, of t
he G-Tech RA
n to the lock ho
the enclosure.
ou remove the faile
-SPEED eS units ar
it is a good idea t
h Port # the array
RESULT IN THE
CONTENT STORE
e 19
he
ID
ole
ed
re
to
is
ED
