Page 6
ref page 3
The 3G Auto Dialler has a 8 amp relay output which can be used to switch on external
electric devices such as lighting, sirens etc.
By texting the unit you can turn the relay ON or OFF. Below are examples on how to do
this.
- This will turn on relay output
-This will turn off relay output
After each operation the unit will reply with a status report
ref page 3
The relay can also be setup to pulse for 20 seconds when the inputs have been triggered.
To activate this mode you need to set
DIPSWITCH 2
ON
position. Ref page 3
This can be used to reset auxiliary equipment.
The 2G/3G PIR and IR Beam Detector has two independent input’s
Input 1 =
Detect and Auto Reset &
Input 2 =
Alarm Detect
—-—––––––––––––––-—–-—–––––-—–––-—–-—–––-—–-
Input 1:
The unit Is always armed and will trigger when the movement is detected, it will
automatically reset after 20 Seconds when no movement is detected. you will receive a text
message “
INPUT DETECTED”
Input 2:
If you decide to use Input 2 you will need to set the alarm to ON by sending a text
message.
#
ALARM
=
ON
#
this will activate the alarm.
When movement is detected you will receive a text message “
ALARM TRIGGERED”.
It is important to remember That when the alarm has been triggered you will need to reset the
alarm by sending another text message
#
ALARM
=
ON
#
To cancel the alarm send a text message
#
ALARM
=
OFF
#
When the inputs are triggered the
GREEN READY LED
will flash 6 times to indicate that a trigger
has been received and it will send a text / call message to the saved user numbers
HOW TO USE THE 2G/3G PIR & IR BEAM
Note:
