Program Keypad Entry
You can open the gate via the keypad with a 4 digit keypad access code. (Up to 50 codes can
be stored). The keypad is independent from the rest of the intercom. It does NOT need a
signal or even a simcard to work.
To add your keypad numbers, simply enter keypad admin mode. This is done by switching
dipswitch 2 to on - the
red
LED will come on to indicate you are in keypad admin mode.
You can now enter a 4 digit code and assign the code to either relay 1 or relay 2. This is done
by either the
#
or
*
key after entering the 4 digit code.
Example you type - 1234
#
To assign relay one (could be full access to property)
5412
*
To assign relay two (could be pedestrian access to property)
If the code is accepted you will hear 4 beeps. If you make an incorrect entry you will hear a
singular long beep and you will need to start again.
To delete a stored 4 digit code enter the 4 digits followed by the zero key to confirm. If the
code is deleted successfully you will hear 6 beeps. If you make an incorrect entry you will
hear a singular long beep and you will need to try again.
Example you type - 54120 Deletes the code 5412
NOTE
- To delete all keypad codes type 00000
Example - 00000
Once your numbers are stored you will need to turn dipswitch 2 back to the OFF position.
Failing to do this will will mean the keypad is unusable as it will still be in admin mode.
How to operate keypad
Type in the 4 digit code. It will operate the relay you have programmed as above.
Relay Pulse Time
The default pulse time for each relay is 2 seconds. You can increase this to 10 seconds for
each relay via dipswitches 3 and 4. Please see dipswitch settings on Page 10.
Page 9
www.gsm-activate.co.uk
- 01273462380 - [email protected]
