www.g-lites.com
7
upside-down, side mounted, or set on a flat level surface, etc. Be sure this fixture
is kept at least 0.5m (1.5 feet) away from any flammable materials (decoration
etc.).
When clamp mounting; always use and install the supplied safety cable as an
added safety measure to prevent accidental damage in the event of a clamp
failure. See the image below.
8. POWER SUPPLY AND SIGNAL CONNECTION
1. Power supply
Use the professional plug to connect the projector and main power supply.
Please pay attention to the voltage, frequency the same as the mentioned on the
projector. Suggest each light has separately switched of the power supply so that
could turn on or turn off each projector desultorily.
2. Signal connection
Please use the round 3-pin XLR plugs & sockets offered by menu facture to
connect the first projector's output to the second projector' input and connect the
second projector's output to the third projector's input. And in the same way for
the rest, eventually connect the last projector's output, all the projectors are
together as the following figure.
