FLATLINE VAN CO • [email protected] • 888-667-5576
6
3.
NOW TAKE THE NUDGE BAR AND REST IT ON THE FRONT STEP AREA. LINE
UP THE MOUNTING SLOTS AND THREAD IN THE HARDWARE SHOWN BELOW.
THE LARGE WASHER GOES UNDERNEATH THE HEAD OF THE M8 BOLT.
THREAD THIS FINGER TIGHT.
NOTE-
THIS IS A TWO HANDED OPERATION THAT IS NOT TOO TRICKY.
WE FIND IT BEST TO HOLD THE NUDGE BAR DOWN WITH ONE HAND
ON THE FRONT TUBE BY THE MOUNTING BRACKET AND USE YOUR
OTHER HAND TO THREAD THE BOLTS IN.
WE RECOMMEND APPLYING BLUE LOCTITE TO THE BOLTS BEFORE
INSERTING
THEM.
4.
NEXT, HOLD THE NUDGE BAR TIGHT AGAINST THE BUMPER AND ENSURE IT
IS CENTERED, THEN TIGHTEN THE HARDWARE.
NOTE-
THERE ARE TWO HOLES BEHIND THE LICENSE PLATE
BRACKET FOR THE USE OF TWO SELF TAPPING SCREWS
(NOT INCLUDED) INTO THE BUMPER PLASTIC IF YOU SEE FIT. THIS
WILL KEEP THE BUMPER SNUG TO THE NUDGE BAR FOR AN EVEN
STURDIER
INSTALLATION.
M8-1.25 X 40 FLANGED HEX
HEAD SCREW
M8 SCREW X 24 O.D.
OVERSIZED FLAT WASHER
SET IN PLACE AND THREAD IN HARDWARE
