Original Bedienungsanleitung FUXTEC FX-WP Serie_de_en_fr_ita_rev09
37
28.
Troubleshooting
1. Difficulties during commissioning
Situation
Cause
Solution
No ignition
spark
Spark plug
Carbon deposit between the
diodes of the spark plug
Clean the spark plug.
Adjust the gap
0.6~0.7mm, replace
the spark plug
Other
Ignition coil defective flywheel
magnet too weak
Replace the ignition
coil or flywheel
Weak
ignition
spark
Compression
Too much gasoline in the
combustion chamber, bad fuel or
water in the tank
Remove the spark
plug and allow to dry,
replace fuel.
The carburetor does
not pump oil
anymore.
Oil line blocked
Cleaning the
carburetor and
cleaning the pipes
Regular oil supply
but weak
compression
Piston rings worn, spark plug not
screwed down, cylinder head not
tight wrong valve clearance or
ignition timing.
Replace screw tight
replace or adjust
Regular oil supply
and good ignition
spark
Poor contact between ignition cap
and spark plug
Replace or check
2. Difficulties during operation
Situation
Cause
Solution
The engine does
not reach the
speed
Choke is in "COLD START" position, the
exhaust system is blocked, no air supply,
moving elements worn, ignition spark
weak too large valve clearance, cylinder
head sooty
Open choke, replace exhaust system
Check or replace ignition coil, adjust
flywheel, spark plug
Operating
materials are
leaking
Lines to carburetor blocked Spark plug
spacing incorrect
Replace lines and carburetor Adjust
gap dimension
Engine
Noises
Wrong choke position,
Camshaft damaged
Check/replace camshaft
Carburetor
leaking
Failure of the check valve on the tank cap
Replace the fuel filler cap
The carburetor gasket is worn out
Replace carburetor or gasket
