Original User Manual FUXTEC chainsaw FX-KS142_KS146_rev08
20
10.
Operating the chainsaw
The saw-chain starts to rotate as soon as the motor starts, so make sure
that there is a sufficient safety distance
CHECKING THE OIL SUPPLY
After starting the engine, run the chain at
medium speed and check that the chain is
throwing oil, as shown in the figure.
(1) Chain oil
The amount of oil supplied can be regulated
by inserting a screwdriver into the opening at
the bottom of the
coupling side is inserted. Adjust the oil supply
quantity according to working conditions.
(1) Chain oil flow adjustment screw
(2) Less oil
(3) More oil
NOTE
It is possible that the oil tank will also empty
during fuel consumption. Therefore, make
sure that the oil tank is filled with oil each
time the saw is refuelled.
is filled up.
CARBURETTOR ADJUSTMENT
According to EU II the carburettor can only be
adjusted with a special tool. Therefore, the
chainsaw must be adjusted by a specialist
dealer. Please contact your local specialist or
the manufacturer directly.
Start the saw and let it run at medium speed
for about half a minute (so it gets a little
warm)
Summary of Contents for FX-KS142
Page 1: ......
Page 17: ...Original User Manual FUXTEC chainsaw FX KS142_KS146_rev08 17...
