00035849.DOC, Version 1.0
28/31
If several FUTURELIGHT POS-60 MK2 LED POWERSTICKs are addressed similarly, they will work
synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the POS-60
MK2 LED POWERSTICK via your lighting controller.
Note:
The modes of DMX 512 data are shown via the display:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the the display will show
"A.001"
with the actually set address. If there is no data received at the
DMX-input, the display will show
"A001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
DMX mode (4 optional modes)
DMX-channels
DMX-mode
LED
Control
Internal
Programs
Strobe
Dimmer/
Speed
63
Individual LED control,
Internal programs, Strobe,
Dimmer/Speed
1~60
61
62
63
60
Individual LED control
1~60
15
5 LEDs form a group
1~12
13
14
15
6
R, G, B control per group
1~3
4
5
6
Control-channel - Internal programs
Decimal Hexad. Percentage S/F
Feature
0 10
00 0A
0% 4%
S No function
11 40
0B 28
4% 16%
S Internal program 1
41 70
29 46
16% 27%
S Internal program 2
71 100
47 64
28% 39%
S Internal program 3
101 130
65 82
40% 51%
S Internal program 4
131 160
83 A0
51% 63%
S Internal program 5
161 190
A1 BE
63% 75%
S Internal program 6
191 220 BF DC
75% 86%
S Internal program 7
221 255 DD FF
87% 100%
S Internal program 8
Control-channel - Strobe
Decimal Hexad. Percentage S/F
Feature
0 0
00 00
0% 0%
S Open
1 95
01 5F
0% 37%
F Strobe-effect with increasing speed
96 127
60 7F
38% 50%
S Open
128 159
80 9F
50% 62%
F Pulse-effect in sequences
