Future Design MCT-CM, User Manual

Page: 91 / 247

MCT-CM
91
The Overview screen contains two scrolling lists. The list on the left contains all loop and monitor information.
To change the set point of a loop, touch the row of the desired loop. The numeric keypad will then be shown
allowing a new set point to be entered.
The list on the right contains the system events (if configured). To turn the system events on and off, press the
on/off button for the event that you want to turn on or off to toggle the on/off state of the event. When turned
on, any digital outputs configured for the event will turn on.
The currently loaded program, or status of a running ramp/soak program will be displayed at the bottom left of
the screen. The Overview will also display all current alarms that have not been cleared from the Alarm screen.
The alarm field will automatically scroll through each alarm, displaying one at a time every few seconds until all
alarms have been cleared.
5.5.3 Alarm Set Points
The ‘Alarm’ button on the Overview screen provides quick access to the alarm set points for all alarms
configured in the system. This allows a user to adjust an alarm set point without having to enter device settings
and accessing the main alarm setup.
The Alarm Settings window will be displayed upon pressing the Alarm button. It will display the alarm message
and provides access to the low and high set points for alarm 1 up to the maximum number of alarms given user
set point access in the configurator. To exit the alarm settings, press the Return button. The left and right
arrow buttons allow you to cycle through each available alarm.