Future Design MCT-CM, User Manual

Page: 112 / 247

MCT-CM
112
7.3 Setting User Access
The
“Access” tab provides the administrator the ability to assign rights to each user level (System, User,
Supervisor and Administrator). To enable or disable specific program functions (user rights) for each user level,
select the user right from the list and press the corresponding on/off button for the user level you want to change
access rights for. If the button is set to on, user access will be enabled for the user group.
User access for
“Security” cannot be disabled for the administrator group. This is a safety feature to make sure
that any administrator with the proper user ID and password can access security. If the administrator losses
his/her ID or password, there is no
“back door” to the system and it will have to be reset and reprogrammed in
order to return to normal operation.
7.3.1 Security System User Access
Shown below is a list of the available user rights, where to find the menu item(s) applicable to the user right and
a description of what it applies to. Note that the OEM configuration allows many menu items to be disabled; in
which case the menu for a specific user right may not be shown.
User Right Menu Location Description
Setpoint Edit View/Loop, Overview applies to loop controls when not running an automatic
ramp/soak program (does not apply to loop/monitor
alarms)
Events View/Overview applies to enable or disable system events
Manual Output View/Loop enable or disable loop control output control