Page
2
of
5 // email [email protected] US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577
Features
Programmable maximum height
3 programmable intermediate heights
Home position (Lift out, telescope retracted)
Configuring programmable heights
1.
Apply power.
2.
Use the FA remote for the whole of the setup procedure
3.
For all commands beginning with [STORE], press each button sequentially with
no more than 2 seconds between each press
4.
In order to store programmable heights you must first enter programming mode.
In programming mode the lift then the telescope will move sequentially
a.
Press [STORE] [STORE] [PRESET] to enter programming mode.
b. IMPORTANT- The mechanism will start to move out as soon as
[STORE] [STORE] [PRESET] has been keyed in.
c.
Once in programming mode the lift will move fully out, followed by the
telescope. Once this has happened the [IN] and [OUT] commands will
only control the telescope.
5. Program the Maximum OUT position (max telescope extension)
a.
Position the lift at the correct height using the IN and OUT commands
b.
Press [STORE] [OUT] to store the current height as the maximum
extension.
