MODEL NAME
:
assigns a name to the current model memory. By giving each model a name that is immediately
recognizable, you can easily comfirm the correct model, and minimize the chance of flying the wrong model memory which
could lead to a crash.
Adjustability and values:
•
Up to 6 characters long.
•
Each character may be a letter, number, blank, or a symbol.
•
The default names assigned by the factory are in MDL-xx format (
MDL-01
for
first model memory, etc.)
NOTE
: When you
COPY
one model memory over another,
everything
is copied, including the model's name. Similarly, if you
change
MODEL TYPE
or do a
MODEL RESET
, the entire memory is reset, including MODEL NAME. So the first thing you will want
to do after you
COPY
a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
GOAL of EXAMPLE:
STEPS:
INPUTS:
27
Name model 3 "CAP-01" (where
the underline represents a blank
space.)
Where next?
Open
MODEL
submenu.
Confirm you are currently using the
proper model memory. (Ex: 3)
Go to
NAME
and change the first
character. (Ex: M to C)
Choose the next character to change.
Repeat the prior steps to complete
naming the model.
Close.
for 1 second.
(If
ADVANCE
,
again.)
to
MODEL
.
If
SELECT
does not indicate 3,
perform
MODEL SELECT
, p. 25.
to
C
.
to
A
Repeat.
Change the
MODEL TYPE
to helicopter: see p. 28.
Change the receiver modulation setting from
PPM
to
PCM
or vice versa: see p. 28.
Utilize servo
REVERSE
: see p. 31.
Adjust servo travel with
END POINT
: see p. 32.
Set up dual/triple rates and exponential (
D/R,EXP
): see p. 34.
