Receiver
Aircraft (
ACRO
)
Helicopter (
HELI
)
Output and
Channel
1
ailerons/combined right flap & aileron
1
aileron (cyclic roll)
2
elevator
elevator (cyclic pitch)
3
throttle
throttle
4
rudder
rudder
5
spare/landing gear/combined left flap and aileron
1,2
1,2
1,2
spare/gyro
6
spare/ flap(s)/combined left flap and aileron
pitch (collective pitch)
7
spare/combined left flap and aileron
spare/governor
14
1
2
Flaperon mode. (See p. 43).
Within flaperon, the second aileron servo can be assigned to channel 5, 6 or 7. (See p. 43)
CHARGING THE Ni-Cd BATTERIES
Charging Your Systemís Batteries
1. Connect the transmitter charging jack and airborne Ni-Cd batteries to the transmitter and receiver connectors of the charger.
2. Plug the charger into a wall socket.
3. Check that the charger LED lights.
The initial charge, and any charge after a complete discharge,
should be at least 18 hours to ensure full charge. The batteries
should be left on charge for about 15 hours when recharging the
standard NR-4J, NR4F1500 and NT8S600B Ni-Cd batteries.
We recommend charging the batteries with the charger
supplied with your system.
Note that the use of a fast charger
may damage the batteries by overheating and dramatically
reduce their lifetime.
You should fully discharge your system's Ni-Cd batteries periodically to prevent a condition called memory.
For
example, if you only make two flights each session, or you regularly use only a small amount of the batteries' capacity, the
memory effect can reduce the actual capacity even if the battery is fully charged. You can cycle your batteries with a commercial
cycling unit*, or by leaving the system on and exercising the servos by moving the transmitter sticks until the transmitter shuts
itself off. Cycling should be done every four to eight weeks, even during the winter or periods of long storage. Keep track of the
batteries' capacity during cycling; if there is a noticeable change, you may need to replace the batteries.
*Note that your 7C transmitter system is protected from accidental reverse polarity, power surges and other electrical
damage by a diode. The transmitter battery must be removed from the system to cycle. The battery easily unplugs from the
battery compartment and has a standard J-plug for easy cycling.
DO NOT
attempt to charge your 8-cell transmitter pack on the 4-cell receiver plug of the wall charger!
Charger
TX: Transmitter charging indicator
RX: Receiver charging indicator
To transmitter charging jack
Receiver Ni-Cd battery
RECEIVER AND SERVO CONNECTIONS
