Furuno TZTL12F, Installation Manual

Page: 47 / 67

3. HOW TO SET UP THE EQUIPMENT
3-13
Transducer Setup menu
*:
This item is only available for DFF3 users.
When [Transducer Setup Type] is set to [Model] and connected to DFF3
When [Transducer Setup Type] is set to [Manual]
Menu item Description
Options
(setting range)
[Transducer Setup
Type] Select the type of transducer connected.
When the connected sounder is a DFF1-UHD and the
transducer has a compatible TDID, [TDID] is automati-
cally selected.
• [Manual]: Manually set up the transducer.
• [Model]: Select the appropriate transducer model
(for FURUNO or AIRMAR transducers)
• [TDID]: Select the TDID for the transducer (for
AIRMAR transducers with a TDID)
[Manual],
[Model],
[TDID]
[Model Number] Select the appropriate model number from the list.
Note: Only available when Transducer Setup Type is set to [Model].
[High Frequency Min] Display the high frequency minimum.*
[High Frequency Max] Display the high frequency maximum.*
[Low Frequency Min]
Display the low frequency minimum.*
[Low Frequency Max] Display the low frequency maximum.*
[Reset Default Set-
tings]
Reset the Transducer Setup menu settings to default. [OK], [Cancel]
Menu item Description
Options
(setting range)
[High Frequency] Select the model and frequency (HF & LF) of the connected
transducer from the appropriate drop down menu.
[Low Frequency]
Menu item Description
Options
(setting range)
[High Frequency (KHz)] Set the kHz frequency for high frequency. Setting ranges vary
depending on the transducer connected.
[Transducer Power HF] Set the transmission power for high frequency.
Note 1: This menu item is available only for
DFF1, DFF1-UHD, BBDS1 and internal fish
finder users.
Note 2: For DDF1-UHD users, when the con-
nected transducer TDID is not supported by the
DFF1-UHD, the setting is fixed as [1000].
[600], [1000]
Band Width (HF) Set the bandwidth for high frequency.
Note: This item is only available for DFF3 users
when the Transducer type is set to [Manual].
[10] to [100]
[Low Frequency (KHz)] Set the kHz frequency for low frequency. Setting ranges vary
depending on the transducer connected.