Furuno TZT19F, Installation Manual

Page: 26 / 58

2. WIRING
2-4
2.5 MULTI Cable
Use the MULTI cable for the NMEA0183 equipment, external buzzer, event switch and
power switch. The connector has 9 wires and a connector (SMP-11V). Use the table
below for reference when connecting the MULTI cable.
2.5.1 How to set up NMEA0183 data output
Note: To set up data input from NMEA0183 equipment, see "NMEA0183 equipment
data input" on page 2-7.
1. Tap the [Home] icon ( ) to show the home screen and display mode
settings.
2. Tap [Settings], then scroll the menu to show [Initial Setup]. Tap [Initial Setup].
3. Scroll the menu to show [NMEA0183 Output], then tap [NMEA0183 Output].
4. Tap [Baud Rate] to set the output baud rate. Available options are [4,800], [9,600]
and [38,400].
5. Tap the appropriate setting then tap the icon.
6. Tap [NMEA-0183 Version] to set the version. Available options are [1.5], [2.0] and
[3.0].
7. Tap the appropriate setting then tap the icon.
8. Tap the flipswitch to set the sentence to [ON].
9. Tap the [Close] icon at the top right of the screen to close the menus.
Wire color Function Pin No. Remark (Port No.)
White NMEA-TD-A 1
NMEA0183 Output
Blue NMEA-TD-B 2
Gray EXT_BUZZER 3 External buzzer ON/OFF
Red +12 V 4 External buzzer power (12 V)
Orange EVENT_SW 5 Event switch (MOB, etc.)
Black GND 6 Grounding
Purple POWER_SW 7
Power switch
Brown DC_N 8
Black DRAIN 11 Grounding