Furuno TZT19F, Installation Manual

Page: 23 / 58

2-1
2. WIRING
2.1 Interface Connections (Rear of Unit)
VIDEO-IN 1/2 VIDEO-IN 1/2
USB1 USB1
USB2
microB USB2
microB
HDMI
IN/OUT HDMI
IN/OUT
NMEA2000 NMEA2000
NETWORK1/2 NETWORK1/2
DI-FFAMP DI-FFAMP
EMI
Core
Rear of TZT19F Rear of TZT19F
MULTI cable MULTI cable
* 1 : Lay the ground wire away from this unit’s power cable.
* 2 : Use of the extension cable (C332 10M) may cause the following problems:
- Reduced detection ability
- Wrong ACCU-FISH™ information (fish length smaller than actual length,
fewer fish detections, error in individual fish detection).
- Wrong speed data
- No TD-ID recognition
* 3 : Depending on the transducer type, 12-10P conversion cable is not required.
Power Cable
FRU-3P-FF-A002M-
001
䠄
2 m, supplied)
TO: Transducer or to
Fish Finder Power
Amplifier DI-FFAMP
Transducer Cable
*2
TO: Ship’s ground
Ground wire
(Local supply,
IV-8sq.)
* 1
TO: 12 to 24 VDC
12-10P
Conversion Cable
FRU-CCB12-MJ-01
(0.4m, supplied) *3