Furuno TZT16F, Installation Manual

Page: 14 / 67

1. MOUNTING
1-6
2. Place the TZT16F face-down on a soft, clean surface, then fit the washers and
knob bolts as shown in the figure below, leaving a gap of approximately 30 mm.
The washers have a leading edge which must face the unit.
3. Set the TZT16F unit to the hanger and tighten the knob bolts.
1.2 Installation of Transducers
Note: For instructions regarding installation of network fish finder transducers, see the
respective manual.
Knob Knob
Washer Washer
Washer leading edge
Hanger
Knob bolt Knob bolt
CAUTION
Do not cover the transducer with FRP resin.
The heat generated when the resin hardens
may damage the transducer. CHIRP transduc-
ers are especially vulnerable to heat.