Furuno GS-100, Operator'S Manual

Page: 37 / 157

3. SETTINGS
3-9
3.6.4 How to restart heading data output after restoration of heading
data
Heading data can be output automatically or manually after heading data is restored.
Note: If there is no heading data, the 3-axis speed data can not be output.
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [4 Other].
3. Select [4 HDG Output Restart Mode].
4. Select [1 Manual] or [2 Auto].
[Manual]: Manually resumes the heading data output after
heading data is lost. Press the
ACK key to acknowledge the in-
dicator alert message and resume the heading data output.
[Auto]: Automatically resumes the heading data output after heading data is lost.
Note: For [Manual], the color for the heading icon changes as follows (see
page AP-9):
• The icon is blue when the heading is calculable.
• The icon is gray when the heading is not calculable.
5. Press the MENU ESC key to close the main menu.
3.7 Device List
The Device List, which shows the particulars about the devices in the system, can be
shown from the menu or by operating the
LIST key (see section 1.5).
3.7.1 How to open the device list from the menu
1. Press the MENU ESC key to open the main menu.
2. Select [6 Sensor Setting] then [9 Device List].
3. Press the MENU ESC key to close the main menu.
Address
Load Equivalency
Number
2051591- xx. xx
000
001
21
10
11
GN 3D
-