Furuno GP-3700F, Operator'S Manual

Page: 99 / 224

7. DESTINATION
7-7
4. Select the route to change. The [ROUTE NAME/ENTER COMMENT] window ap-
pears.
5. Select [RUN] to display [RTE TRN PT LIST].
6. Select the waypoint to skip then press the
CURSOR ON/OFF key. "-" appears in
[DISTANCE], [TTG] and a field before [WPT].
Note: To restore a waypoint, select it then press the CURSOR ON/ OFF key.
7. Press the DISP key to close the menu.
How to select the waypoint switching method
When your vessel arrives at a waypoint, the waypoint is automatically switched to the
next sequential waypoint. You can select the switching method from [WPT ON VER-
TICAL LINE] or [ARRIVE ALARM WITHIN RANGE].
[WPT ON VERTICAL LINE]: Automatically switches the waypoint to the next sequen-
tial waypoint when the vessel enters the arrival alarm area or the vessel passes an
imaginary perpendicular line passing through the center of the destination waypoint.
For how to set the arrival alarm area, see chapter 8.
[ARRIVE ALARM WITHIN RANGE]: Automatically switches the waypoint to the next
sequential waypoint when your vessel is within the arrival alarm area.
1. Press the MENU key to open the main menu.
2. Select [0. SYSTEM SETTING].
3. Select [1. DISPLAY FORMAT].
4. Select [WPT.REFRESH SETTING] on page 2.
5. Select [WPT ON VERTICAL LINE] or [ARRIVE ALARM WITHIN RANGE].
6. Press the
MENU key to close the menu.
Waypoint to skip
Waypoint 1
Arrival alarm area
Switches to
the next
waypoint here.
[WPT ON VERTICAL LINE] [ARRIVE ALARM WITHIN RANGE]
Waypoint 1
Waypoint 2
Waypoint 2
Switches to the next
waypoint here.