Furuno FSV-75, Operator'S Manual

Page: 200 / 235

10. MAINTENANCE
10-12
10.10.4 Hull unit control box test
The hull unit control box test displays detailed information for your control box. To con-
duct this test, select [4 Control Box Test] from the second page of the [Test] menu.
Press the MENU/ESC key to close the results.
For any NG, contact your dealer for advice.
How to read the test results
(1) HCTL board information and status results.
Results appears as "OK" (white text) or "NG" (red text).
(2) Motor information.
(3) HDRV board information.
(4) HMS board information and status results.
Results appears as "OK" (white text) or "NG" (red text).
(5) Motion sensor information and status results.
Results appears as "OK" (white text) or "NG" (red text).
(6) Motor test results.
Control Box TEST
HCTL
HMS
SW Ver 105-XXXX-XX.XX
CPLD Ver 105-XXXX-XX.XX
PCB Ver 0
ROM = OK
RAM = OK
S1 0010
SW Ver 105-XXXX-XX.XX
PCB Ver 0
ROM = OK
RAM = OK
S1 0000
HCTL
HMS
24V = OK
12V = OK
5V = OK
24V = 23.8
Tacc = 22.3ºC
Tgyr = 16.0ºC
MOTOR HDRV CPLD Ver 105-XXXX-XX.XX
PCB Ver 1
POWER SUPPLY = 24.3V
CURRENT = 1.3A
MOTION SENSOR
(MOTION SENSOR OFFSET INCLUDED)
Accel = OK
Gyro = OK
ROLL = -8.9°
PITCH = -0.2°
Sweep Lever : Operate rotate motor.
Tilt Level : Operate Pitch motor.
Sweep Reset key : Reset motor position.
Menu/Esc key : Cancel
ROTATE
MOTOR
PITCH
MOTOR
AUTO
AUTO
127.4°
0.0° 0.0°
-57.1° OK
OK
OK
OK
OK OK
OK OK
5.7H
0.6H
MANUAL
MOTOR
TARGET POS STEP
MOTOR
POSITION RESOLVER
DETECTED
POSITION MOTOR
DRIVER
STATUS RESOLVER
DRIVER
STATUS MOTOR
SELF TEST RESOLVER
SELF TEST ACTIVE
TIME
*
*: For qualified technicians
OK: Status is normal; NG: Error detected
XX: Program number