Furuno FSV-2S, Operator'S Manual

Page: 79 / 162

3. VERTICAL MODE
3-5
3.3.3 Cursor position reference mark
The cursor position reference mark, a solid circle, is inscribed on the vertical bearing
mark when the cursor is placed in the vertical display. Its purpose is to show corre-
sponding cursor position on the horizontal display. It changes position with cursor po-
sition, tilt and range, and disappears when its position is no longer within the range of
the horizontal display.
3.4 Auto Train
You may scan the vertical bearing mark in the sector of ±12°, ±24° and ±36°. Press
and hold down the
AUTO TRAIN key while pressing the V1/S or V2 key to select the
auto train sector desired. Selected sector appears in large characters for five seconds
for your confirmation. To cancel auto train, repeat the above procedure to select
[OFF].
Note: If both the auto train and the target lock are active in a vertical mode, the follow-
ing restrictions apply:
• V1 mode: Auto train is disabled.
• V2 mode: The auto train for the vertical bearing marker is disabled.
Disable the target lock to restore the auto train.
VERTICAL
DISPLAY
Cursor
Cursor position
reference mark
V
Vertical
bearing
mark
Tilt mark
Vertical bearing mark
Auto train mark
1
Auto train sector