Furuno FSV-2S, Operator'S Manual

Page: 35 / 162

2. HORIZONTAL MODE
2-5
Select tilt angle depending on target fish. For surface fish select a shallow angle
(about 5°) and for bottom fish, a deep angle.
Note 1: In the factory default condition, the tilt angle can also be adjusted by rolling
the scrollwheel. For the H2 display, move the cursor into the display where you want
to change the setting.
Note 2: The tilt angle can also be adjusted from the tilt angle indication. Put the cursor
on the tilt angle indication to highlight it in yellow then roll the scrollwheel.
Note 3: The TILT control functions as a bearing setting lever when the following con-
ditions are met: [Tilt Lever] in the [Display Setting] menu is selected to [Tilt & V1], and
the vertical display is chosen in the vertical mode.
2.4.2 Automatic tilt
The AUTO TILT key automatically scans the tilt angle within the selected width. This
is useful when you want to find the center depth of a school of fish. Wide tilt angle is
activated from the [Auto Tilt] on the [Others] - [Display Setting] menu.
1. Press the AUTO TILT key to select auto tilt angle desired. Each time the key is
pressed the auto tilt angle changes in the following sequence.
2. If necessary, operate the TILT control to change center tilt angle.
In automatic tilt, "AUTO" is displayed at the top right corner. To disable automatic
tilt, select OFF at step 1.
-5°
Tilt angle setting range
0° horizontal direction
(tilt angle 0°)
+60°
17° T
H-UP
P 8
40
50
H R 400m
G 1. 0
Put the cursor on the tilt setting,
which is then highlighted in
yellow. Spin the scrollwheel to
change the setting.
OFF
[
±
1
°
- 4
°
]
[
±
2
°
- 6
°
]
[
±
3
°
- 8
°
]
(Narrow)
OFF
[
±2
°
- 10
°
]
[
±
4
°
- 16
°
]
[
±
6
°
- 20
°
]
(Wide)
R 400m
AUTO
17
°
T
(21
°
)
G 10
N-UP
P 8
H
Current tilt angle
Auto tilt is active