Furuno FR-10, Operator'S Manual

Page: 118 / 171

5. AIS OPERATION
5-8
* The interval at which AIS data is sent depends on speed of the AIS transponder. For
detailed information, refer to the Operator's Manual for the AIS transponder.
Lost AIS targets are automatically removed from the display one minute after they are
determined as lost. You can also remove all lost AIS targets from the display as fol-
lows:
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Erase Lost Targets], then press the ENTER key. A confirmation message
appears.
4. Use the cursorpad (  ) to select [Yes], then press the ENTER key. All lost targets
symbols are erased from the screen and the long beep sounds.
5. Press the MENU key to close the menu.
5.14 Symbol Color
You can select the AIS symbol color among Green, Red, Blue, White or Black.
Note: Symbol colors are not available when [Background Color] (located in the [Brill/
Color] menu) is set to the same color.
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Color], then press the ENTER key.
4. Select the color, then press the ENTER key.
5. Press the MENU key to close the menu.
5.15 How to Ignore Slow Targets
You can prevent activation of the CPA/TCPA alarm against AIS targets that are trav-
eling at a speed lower than set here. The AIS symbols are not affected by this setting.
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Ignore Slow Targets], then press the ENTER key.
4. Set speed (0.0 to 9.9 kn), then press the ENTER key.
5. Press the MENU key to close the menu.