Furuno FCV-38, Installation Manual

Page: 44 / 81

3. INITIAL SETTINGS
3-10
3.4 External Echo Sounder Setting
To set the external echo sounder, two methods are available: from the main monitor
or the sub monitor. If you have a sub monitor and [External Fish Finder Window] (see
page 3-3) is set to [On], the parameters are set from the sub monitor’s menu.
3.4.1 [External Fish Finder Window] setting: Off
The compatible external echo sounder (fish finder) is a DFF3. Set the transducer pa-
rameters from the main monitor as belows:
1. Select the [Advanced Settings] icon ( ) from the InstantAccess bar, then se-
lect the [Advanced Settings] icon ( ) from the menu bar.
The [Advanced Settings] menu windows appears.
2. Select [Service] to expand the service menu.
The message “Ask your dealer to change service settings.” appears.
3. Press and hold the [OK] button for approximately ten seconds to open the service
advanced menu.
4. Select the “External Echo Sounder” from the [Service] menu.
5. Select [DFF3] from the [Connected Fish Finder] menu.
The message appears to reset the settings. Press the [OK] button to close the
message.
6. Select the [TX Triggering] to [On] to enable KP control with the DFF3.
Note: The main transceiver’s TX trigger setting should be [Off] while this external
TX trigger is set [On].
FCV-38[ver 0252473-xx.xx]