Furuno FCR-2829W, Installation Manual

Page: 113 / 174

5-1
5. INPUT/OUTPUT DATA
5.1 Radar Processor Unit
Input and output data are shown in the table below.
Input
*: Data input cycle should be more than 40 Hz (HSC) or 20 Hz (normal ship speed).
Output
*: The output sentence, mode and baud rate can be set at the TT Preset menu.
5.2 Processor Unit
Input and output data are shown in the table below.
Input
*: Data input cycle should be more than 40 Hz (HSC) or 20 Hz (normal ship speed).
Data Specification Contents Remarks
Heading signal sycrhro or step GC-10 required AD-10 and IEC 61162
are switched by menu
setting.
AD-10 format External AD-100
IEC 61162-2*
Data Specification Contents Remarks
Remote display signal HD, BP Trigger, Video 2 ports
Data Specification Contents Remarks
Heading signal IEC61162-2*
Speed signal IEC 61162-1 Ed.4
Navaid data IEC 61162-1 Ed.4 Position, time and
date, datum, course,
speed, wind, current,
depth, temperature,
NAVTEX, etc.
AIS signal IEC 61162-2
Alarm handling
signal Contact closure Input from alarm system
IEC 61162-1 Ed.4 Input from alarm system
NOTICE
The radar(s) must be interconnected to the following type approved sensors :
Gyrocompass meeting the requirements of the IMO resolution A.424(XI).
EPFS meeting the requirements of the IMO resolution MSC.112(73).
SDME meeting the requirements of IMO resolution MSC.96(72).
The radar may be interconnected via HUB-3000 to other FURUNO processing
units having approved LAN ports.